clicks into place. You w
ill hear a click when it is properly fixed.
Choosing the correct attachment
Choose the attachment that best suits the desired haircut or the
area where hair is going to be cut.
Hair trimming attachment
- Thoroughly comb your hair.
- Select a suitable comb attachment (1-2-4-6-8-10-12-14-16
mm) that fits the beard trimmer attachment.
- Begin the haircut with the beard trimmer attachment on the
nec
k or the sides and cut towards the middle of the head. Then
cut the front part of the hair towards the middle of the head.
- Hold the beard trimmer so that the guide comb is flat on the
head. Then run it evenly through your hair.
- If possible, trim the hair against the direction of growth.
- To ensure that you trim all hairs, run the beard trimmer over
the same area of hair several times.
- If the guide comb is not attached, you can use it to trim or cut
very short hair.
- Comb your hair thoroughly again and again.
Hair trimming attachment for trimming beards
Use the 3-4-5-6 mm guide comb over the beard collector if
necessary.
- Comb your beard towards the direction of the hair growth.
- Cut your beard upside down, from ears to chin. First trim a
side and then the other.
- Use the beard trimming attachment without the comb to
trim a very short beard, moustache or outline. The trimmer’s
sharp edge must be placed in a right angle to the beard.
ENGLISH
BAMBA PRECISIONCARE PRO
42
To Next Page
Loading...
Need help?
General
