EN
38
3. BEFORE USE
• Take the product out of the box.
• Remove all packaging materials. Keep the original box.
• Make sure all the components are included and in good conditions,
otherwise, contact immediately the ofcial Technical Support
Service of Cecotec.
• Before the rst use, charge the device for 2 hours for optimum
operation.
4. OPERATION
1. Select the attachment that best ts your personal needs.
2. Assemble the desired attachment to the top part of the device’s
body.
• To remove the shaver trimmer or any other attachment you have
assembled, hold the trimmer body with one hand and pull from
the attachment with the other hand.
• To assemble a different one, insert the attachment into the
trimmer’s slot and push it until it clicks indicating it is tted into
place.
• To assemble the guide comb attachment, introduce the trimmer
attachment inside the comb attachment and lock into place the
attachment’s xing tab.
• The guide comb includes a length-adjustment knob. Adjust it from
0.5 mm to 10 mm and adapt it to your desired haircut.
• To remove the comb attachment, pull the back part off the product
until the xing tab is released and then slide the comb off the
blade.
3. Hold the lower part of the product’s body with one hand and turn
the top part anticlockwise to turn the device on and clockwise to
turn it off.
To Next Page
Loading...
