EN
41
5. CLEANING AND MAINTENANCE
• Turn off and disconnect the device from the mains supply before
cleaning, maintaining it or assembling or disassembling any of its
parts.
• Do not use compressed air, abrasive scouring pads, powders or
cleaners to clean the product.
• Do not immerse the appliance’s body in water or any other liquid,
or place it under running water.
• To clean the attachments, rst remove it, brush it with the
cleaning brush and blow out hair clippings from the attachment
and the body.
• Attachments are waterproof; therefore, they can be washed with
water if necessary. Dry them thoroughly before storing or using
them again.
• Clean the trimmer and the attachments after each use with the
cleaning brush. Remove the attachment and rinse it under warm
running water. Do not use hot water.
• To clean the shaver:
• Rinse the shaving attachment under running water. Use the
cleaning brush at the same time if necessary.
• Carefully shake off excess water and let the shaving unit
dry. Do not dry it with a towel or tissue, as this may damage
the shaving heads.
Warning: Do not rinse the shaver attachment as this is permanently
lubricated
Oiling blades
• Rinsing attachments under water (above) requires lubricating the
cutting blades once per month. Using only light-grade oils (e.g.
sewing machine oil), simply spread 1-2 drops lightly over cutters
with the ngertip. Wipe away all excess.
• Use only light-grade oils as these will not evaporate nor slow
down the speed of the cutting blades.
• Do not use hair oil, grease, or any oil mixed with kerosene nor
solvent as these too will evaporate.
To Next Page
Loading...
