BAMBA RITUALCARE WET&DRYBAMBA RITUALCARE WET&DRY
2827
ENGLISH
ENGLISH
- Make sure all parts and components are included and in
good conditions. If any visible signs of damage are observed,
contact the Technical Support Service immediately.
3. OPERATION
Recommendation
It is suggested to use this hair straightener on thick and abundant
hair, as well as using thermal protector products previous to hair
ironing to ensure total care.
- This hair straightener can be used on dry and damp hair.
- Make sure the hair that is going to be straightened is clean,
free from hair spray, gel and other products.
PARTS AND
COMPONENTS
Fig. 1
1. Fixing clamp
2. On/Off switch
3. Lower plate
4. Steam vents
5. Top plate
2. BEFORE USE
- Take the product out of the box.
- Remove all packaging material. Save the original box.
Warning
Avoid touching the scalp with the device to prevent skin damage.
4. CLEANING AND MAINTENANCE
- Turn off and disconnect the device from the power supply and
allow it to cool down completely before cleaning.
- Do not immerse the appliance in water or any other liquid or
place it under running water.
- Place the device on a heatproof surface until it cools down
before cleaning or storing it.
- Use a soft, dry and clean cloth to clean the product.
1. Wash hair and dry it with a cloth or dryer until excess water
is removed.
2. Plug the device into a power supply.
3. Place the appliance on a flat, stable and dry surface.
4. Turn the switch on and allow the appliance to heat for 3
minutes approx.
5. Select a hair section, 5-cm wide and 1-cm thick approx. Hold
it straight with one hand, introduce it between the plates
and, holding the appliance with the other hand, close it and
slide it from roots to ends.
6.
Repeat this step with the rest of the hair until you obtain the
desired hairstyle.
7. Wait until hair cools down and comb it.
To Next Page
Loading...
Need help?
General
