EasyManuals Logo

cecotec BOLERO 10500 INVERTER A User Manual

cecotec BOLERO 10500 INVERTER A
Go to English
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
BOLERO DRESSCODE 10500 INVERTER A
BOLERO DRESSCODE 10500 INVERTER STEEL A
61
ENGLISH
B. Factory state
- Lock nuts on the bottom of the washing machine
- Levelling feet tted to the lock nuts
Please note
The levelling feet do not come fully xed for easier installation, so be sure to x all four before
levelling the washing machine.
1. When positioning the washing machine, you should check if the levelling feet are fully
xed; if not, x them. The lock nuts must be rmly locked to the bottom of the appliance
and the levelling feet securely locked into the lock nuts. Fig. 7
2. Once the washing machine is installed, press on the opposite corners of the top with both
hands in succession and shake the washing machine vertically downwards to check if the
levelling feet are rmly xed and that the washing machine does not wobble. Fig. 8
3. If the washing machine wobbles, loosen the lock nut in the direction shown in Figure 9
with the spanner provided until the machine is level and no longer wobbles. Fig. 9
4. Finally, use the spanner to x the lock nut to the bottom of the washing machine (you can
also x the levelling feet lightly by hand to prevent them from moving). Make sure the
levelling feet do not move. Fig. 10
Warning
1. The washing machine must be perfectly level and stabilised when all four feet are rmly
on the oor.
2. Incorrect levelling adjustment may cause loud noises, vibrations of the washing machine,
shifting of the washing machine, and other abnormal occurrences.
3. The air vent is located at the bottom of the washing machine (to avoid obstructions).
Install the washing machine on a solid, smooth, non-slip oor. Do not place the washing
machine on a soft blanket or wooden oor or on top of furniture, as this may cause
unnecessary injury.
4. OPERATION
Installing the washing machine
Connecting the inlet hose. Fig. 11
1. Connect the inlet hose to the tap and x it by turning it counterclockwise.
2. Connect the other end of the inlet hose to the inlet valve on the back of the washing
machine and secure it rmly clockwise.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the cecotec BOLERO 10500 INVERTER A and is the answer not in the manual?

cecotec BOLERO 10500 INVERTER A Specifications

General IconGeneral
Brandcecotec
ModelBOLERO 10500 INVERTER A
CategoryWasher
LanguageEnglish

Related product manuals