CECOFRY EXPERIENCE WINDOW WHITE 6000
CECOFRY EXPERIENCE 6000
CECOFRY EXPERIENCE WINDOW 6000
28
ENGLISH
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the Technical Support Service
of Cecotec.
- Clean the basket and rack thoroughly with hot water, washing-up liquid and a non-abrasive
sponge.
- Clean both the interior and the exterior of the device with a damp cloth.
- Make sure all parts of the air fryer are completely dry and place the rack in the basket
properly.
- Place the air fryer on a stable, flat surface.
Warning
- Do not wet the heating element inside the fryer.
- Do not fill the air fryer with oil or any other liquid.
- Do not place the device on any surface that it is not heat-resistant.
Note
You may notice a slight burning smell or smoke when using the fryer for the first time, caused
3. OPERATION
1. Place the air fryer on a stable, flat surface.
2. Connect it to a mains socket.
3. Use the handle (4) to remove the basket (3), do it carefully. Make sure the rack (5) is
correctly placed in the basket (3).
4. Put the ingredients inside the basket (3).
5. Place the basket back (3). The fryer has a safety system that will not allow you to use it if
the basket is not in place (3).
6.
fryer will start operating.
7.
you wish to end the cooking process, hold down this icon (7) for 3 minutes. If you do not
press any icon for the next minute after pausing, the fryer will enter standby mode and
will beep 3 times.
8. When you hear an alarm, it means that the preparation time has come to an end. Use the
handle (4) to remove the basket (3). Depending on the type of ingredients, steam may be
released, so be careful when removing the basket (3).
9. Check if the ingredients are cooked as desired. If not, put the basket (3) back inside the
device and set the timer for a few more minutes.
To Next Page
Loading...
