Tips:
- We recommend the use of liquid degreaser for food use to remove any remaining dirt.
- If the basket and grille are very dirty, soak them in hot water and cleaning solution for
10 minutes.
1. Clean the inside of the appliance with hot water and a non-abrasive sponge, taking
care not to damage the resistance.
2. Clean the spray nozzle with hot water and a non-abrasive sponge.
3. Remove the protection grille and clean the grease with hot water, detergent and a non-
abrasive sponge.
4. To clean the tank and internal oil tubes, you can enter the DIY mode and at oil level 0
you can press the DIY button until the tank and internal tubes are empty, the device will
indicate that there is no more oil left by means of the “Add Oil” notice.
Storage
1. The power cable can be stored inside the appliance.
2. Make sure all components are clean and dry.
3. Be sure to clean the sprayer and the removable protective
grille.
5. TROUBLESHOOTING
Problem Possible causes Possible solutions
E1
Temperature
sensor not working
Contact the official Cecotec
Technical Support Service.
E2
Temperature
sensor not working
Contact the official Cecotec
Technical Support Service.
The air fryer does
not work
The appliance is
not plugged in.
Connect the power cable to an
earthed plug socket.
Cooked foods are raw. The food is too big.
Put smaller batches of food in the
basket. Smaller batches are cooked more
evenly.
The temperature
used is too low.
Select a higher temperature (see
the “Operation” section).
The preparation
time is too short.
Select a longer time (see the
“Operation” section).
03305_CECOFRY RAIN PACK.indd 5803305_CECOFRY RAIN PACK.indd 58 30/6/23
12:3530/6/23 12:35
CECOFRY RAIN PACK
42
ENGLISH
To Next Page
Loading...
