16
• Turn the appliance off and disconnect it from the mains
supply before changing accessories!
• Use this appliance only to process foods.
• Do not operate the appliance for more than 10 minutes
without pauses. Let it cool down for approx. 10 minutes
before using it again.
• Do not move the appliance while in use; always turn it off
rst and disconnect it from the mains supply. Always carry
the appliance with both hands!
Electric Connection
Make sure that the rated power of the mains supply matches
the one specied on the rating plate of the appliance.
3. COMPONENTS
OPERATION
1. Turn the swivelling arm adjustment following the arrow direction (3) to lift the machine’s
arm.
2. To use the whisk (8c) attach the splash guard rst (6): hold the splash guard with the
collar upward.
Note:
At the bottom of the arm you can see two grooves on the left and right side.
Slide the splash guard into these grooves and turn it clockwise to lock.
Note:
The splash guard is not necessary when preparing dough with the kneading hook or the mixing
blade. This allows you to add ingredients during the process.
3. Attach the protection disc (7) when using the kneading hook (8a). It stops the rising dough
from touching the driveshaft.
4. Hold the disc like you would hold a inner pot. Insert the kneading hook from below through
the opening in the disc and x it turning it approximately 90°.
5. At the upper end of the accessory, you can nd a groove for the driveshaft. Attach
the desired accessory by inserting its upper end into the driveshaft and turning it
To Next Page
Loading...
