cecotec CONGA GRASSHOPPER 800 CONNECTED - Page 19

CONGA GRASSHOPPER 500 CONNECTED
19
- Do not touch moving parts unless they have come to a
complete stop and have been switched o. Individual
hazards: to avoid injury, wear protective gloves and goggles
when servicing or replacing blades.
- Do not touch moving parts, such as the blade disc, before it
has come to a complete stop.
- WARNING: to recharge the battery, only use the power
supply unit supplied with the appliance, reference CGF251
and the charging station CB03A.
- Do not place the charging station in a location where there
is a risk of standing water or where ooding is likely to
occur.
- Do not place the charging station (or any of its accessories)
within 60 cm of any combustible material. In the event of
a malfunction, the charging station and the power supply
may overheat, which could cause a re.
- Do not place the power supply on the oor. Place it at
a minimum height of 30 cm, so that there is no risk of it
coming into contact with water.
- When connecting the power supply to the mains socket,
use a residual current device (RCD) with a tripping current
of max. 30 mA.
- If the cable (or plug) is damaged, do not connect it. If the
cable is damaged and connected to the mains, do not
touch it until it is disconnected. Disconnect the plug from
the socket if the cable is damaged during operation of
the appliance. If the cable is worn or damaged, the risk of
electric shock increases. If the cable is damaged, it must be
replaced by qualied personnel.
- Charge the appliance only in the charging station provided.
- Only use original batteries. The safety of the product
cannot be guaranteed if non-original batteries are used.
Do not use non-rechargeable batteries.