CONGA GRASSHOPPER 500 CONNECTED
125
ENGLISH
LED indicator
lights
Meaning Action required
No indicator
light is on
The charging station is not
connected to the mains.
Check that the power cable is properly
connected to the charging station, and
that the charging station is connected to a
suitable power supply.
Steady green The boundary wire is
correctly connected.
This is normal, no action is required.
The battery is fully
charged.
Flashing green The mower is charging. This is normal, no action is required.
Flashing red The boundary wire is not
connected or is damaged.
Check that both ends of the boundary wire
are securely connected.
Check the boundary wire for damage.
4. OPERATION
1. Once the installation process is completed, the mower will be ready for use.
2. Press the button until the mower switches on. The rst time you do this, enter the
default PIN code (0000). To do so, press four times until number 0 ashes, as shown
in Fig. 9. (See section “Changing the PIN code” if you wish to change it).
Note:
- The mower will switch o after 30 seconds if no operation is performed.
- If an incorrect PIN is entered ten times, the mower will beep and then switch o. You can
try to enter the PIN again after 50 minutes.
- The robot needs the correct PIN to charge.
- While the robot is charging, it will stop emitting an electrical signal through the cable.
3. Press and then so that the mower starts operating.
4. Press and then for the mower to return to its charging station. Before starting the
mower, remember to use the cutting knob to adjust the cutting height (the cutting distance
is in relation to the ground).
- The mower will mow the lawn without interruption until its battery level is low. It will then
return to the charging station. When fully charged, if it is within the operating time range,
it will automatically restart, or remain on the charging station if it is outside the operation
time range.
To Next Page
Loading...