cecotec CONGA ROCKSTAR MICRO+ TURBO - Using the vacuum cleaner; Attachments; Indicator light and Charging; Cleaning and Maintenance

CONGA ROCKSTAR MICRO+ TURBO CONGA ROCKSTAR MICRO+ TURBO
2221
ENGLISH ENGLISH
Using the vacuum cleaner
1. Make sure the vacuum cleaner’s adapter is not connected.
2. Press the power button to turn the vacuum cleaner on.
3. Use the speed-control knob to set the desired speed.
Attachments
objects, and dirt.
Accessory for upholstery. Fig. 2
This accessory is used for an intense cleaning of upholstered furniture.
1. To install the accessory for upholstery to the main body, align the two parts so that they
fit together until it snaps into place.
2. To remove, pull the accessory while holding the main body firmly.
Accessory for corners and furniture. Fig. 3
This accessory allows cleaning furniture without damaging it and reaching less accessible dirt
in corners.
1. To install the accessory for corners and furniture to the main body, align the two parts so
that they fit together until it snaps into place.
2. To remove, pull the accessory while holding the main body firmly.
Motorised brush for upholstery. Fig. 4
1. To install the motorised brush into the main body, align both of them making sure the tab
on the motorised brush matches the guides on the main body, and introduce one into the
other until they are firmly fixed.
2. To remove, press the motorised brush release button and pull it out of the main body.
Indicator light. Fig. 5
- When the vacuum cleaner is charging, the indicator will light up and keep flashing.
- When the vacuum cleaner is fully charged, the indicator will stop flashing and light up
steady.
- When using the vacuum cleaner, the indicator will stay lit.
- When the vacuum cleaner’s battery is low, the indicator will flash.
Charging the vacuum cleaner. Fig. 6
1.
2. Plug the adapter into a socket and the vacuum cleaner.
3. An indicator light will light up and keep flashing once the adapter is connected to the
vacuum cleaner.
- To ensure that the device is always ready for use, we recommend you leave the device
charging when not in use.
- It’s normal for the adapter to become warm during charging.
4. CLEANING AND MAINTENANCE
-
cleaning it.
- Use a soft, slightly dampened cloth to clean the surface of the device.
- Never immerse the device in water or other liquids, do not allow liquids to enter the device.
- Do not use abrasive cleaners or scouring pads to clean the product.
- Do not leave the device in a place with direct sunlight.
- Do not leave the device in a wet place after cleaning it.
Filters and tank cleaning. Fig. 7
- To avoid the appliance from overheating and losing suction power, it is suggested to clean
the filters frequently. To make the most of the suction power, it is suggested to clean the
filter after every use.
- The filters shelf life will depend on the accumulated use and the type of particles which
are frequently vacuumed. It is recommended to replace the filters approximately every 6
months.
1.
2. Press the dust-tank release button and remove it.
3. Remove the filter system from inside the tank and separate the filters for cleaning.
4. Put the filters back in their original position inside the dust tank.
5. Refit the dust tank.
- Vacuum and shake the filters to remove every particle and dust remain that may block
without the filters properly assembled.
- Filters cannot be washed inside a washing machine nor dried with a hair dryer.
-
5. TROUBLESHOOTING
Problem Possible cause Possible solution
The vacuum cleaner
does not work.
The battery is exhausted. Charge the battery.