cecotec FORCECLIMA 12600 SoundLess Heating - Page 33

FORCECLIMA 12600 SOUNDLESS HEATING FORCECLIMA 12600 SOUNDLESS HEATING
6564
ENGLISH ENGLISH

Mode (Remote control)

Note:
drainage will be done through the upper condensate outlet. When the device is running in
heating mode, the condensate drainage will be done through the lower condensate outlet.
Note: when changing from heating mode and vice versa, the appliance will take some time
to change from one mode to the other. It may take a few minutes for the appliance to start
running normally again.
Sleep mode
In cooling mode, press the increase and decrease icons to activate the Sleep mode. The device
will operate saving energy and silently.
Increase and decrease icons
Use these icons to increase or decrease temperature and time.

Fan speed
Under the cooling mode, press the key to select high or low wind speed operation.

NOTE:

Timer
Press this key to set the timer. When the timer symbol blinks, use the increase and decrease
icons to select the desired operating time.
The timer can be set from 1 to 24 hours, and the digits increase and decrease by 1 hour.
Unit switch: (Remote control)
Press the button to switch between ºC and ºF.
Oscillation
Press this button to activate the air oscillation.
Drainage instructions


moving the appliance from one place to another, always do it with the device in an upright

- 


otherwise it may cause overheating.
Installing of the air outlet pipe. Fig. 7
1. Stretch the air outlet pipe.
2. Insert the pipe into the air outlet.
3. 
NOTE:
- 
- The air outlet pipe must not be twisted or bent more than 45°. Keep the air outlet pipe free
of obstructions.
Installing the window sealing plate



- The load size is in accordance with the size of the room where refrigerant-containing parts
are installed.
- Ventilation machinery and outlets can be properly operated and are unobstructed.
- If an indirect cooling circuit is used, the secondary circuit must be checked for refrigerant
presence.
- 
corrected.
- The components or refrigerant piping are installed in a position where they are not
susceptible to exposure to any substance that may corrode the refrigerant-containing
components, unless the components are made of materials that are inherently resistant
to corrosion or are properly protected against it.
4. OPERATION
The following functions can be activated from the control panel or from the remote control.
On/O (Remote control)
When the device is turned on, it will beep and enter standby mode. Touch the power key to turn