58
ENGLISH
GRANDHEAT 2000 FLATBED BLACK/WHITE
If the door is opened during operation, press start to resume operation.
After a program is set, if Start is not pressed within 1 minutes, the settings will be cancelled.
After a program is nished, the device will beep every 2 minutes for 10 minutes.
In standby mode, press Stop/Cancel for 3 seconds or if there is no operation within 10 minutes,
the screen will turn automatically off. Press any key to turn the display on again.
5. CLEANING AND MAINTENANCE
The device, as well as food rests, must be cleaned and removed regularly.
Unplug the cable from the power supply before starting the cleaning. Do not immerse the
product in water or any other uid during cleaning.
The lack of maintenance and cleaning of the product may cause a deterioration on its surface
and affect its lifespan.
Do not use strong detergents, powder abrasives or metal brushes to clean the device.
Do not remove the mica plate.
When the microwave has been used for a long time, some strong odours may arise from inside.
In order to get rid of them, follow one of the steps below:
Place several lemon slices in a cup and heat them at high power for 2 or 3 minutes.
Place a cup of red tea inside the microwaves and heat it at high power for 2 or 3 minutes.
Place orange peels inside the microwaves and heat it at high power for 1 minute.
Use a dampened soft cloth to clean enclosures, door, interior walls and the door frame.
Warning: All maintenance tasks must be strictly carried out by qualied technical personnel.
6. TROUBLESHOOTING
Problem Cause Solution
The device does not turn on The power cord is not
plugged in properly.
Disconnect it and connect it
again after 10 seconds.
Fuse blow or short circuit. Contact the Technical Support
Service of Cecotec.
Faulty power outlet. Test the power outlet with a
different appliance.
The device does no heat Door not closed properly. Close the door properly.
Dim microwave light In low power microwave
operation, the device light
may become dim.
It is normal and does not
affect the device operation.
To Next Page
Loading...
