13
HYDROBOOST 1400 ESSENTIAL
- Do not activate the trigger lock system when the appliance
is in operation.
- Do not operate the appliance unless all parts are properly
connected to the main body (handle, gun, nozzle, etc.).
- Make sure to turn on the water supply before turning on
the pressure washer. Running the pump without water can
cause serious damage to the pump.
- Do not use the pressure washer if any parts are missing or
damaged. Check the condition of the product regularly and
repair or replace damaged or worn parts immediately.
- Use only the nozzle included with the product.
- Do not leave the high-pressure hose unattended while the
device is in operation.
- Hold the high-pressure hose and trigger gun rmly when
switching on and while using the machine.
- Do not leave the appliance running with the trigger released
for more than one minute, as this could damage the pump.
- This device is not designed to pump hot water. Do not connect
the appliance to a hot-water supply, as this will signicantly
reduce the shelf life of the pump.
- Make sure the water inlet pressure is between 0.01 MPa and
0.4 MPa and that the inlet hose is at least 5 metres long.
- If the device is to be connected to a drinking-water supply,
install a disconnector on the water pipe to prevent dirty
water from backing up and entering the drinking-water
system. The disconnector must comply with EN 60335-2-79
ANNEX A.
- This device must not be controlled by external switching
elements such as timers or connected to electrical circuits
that are continuously switched on and o.
- Release the trigger when switching from high to low
pressure.
To Next Page
Loading...
