Why does my Cecotec Pressure Washer have low water content?
If your Cecotec Pressure Washer shows low water content, several issues could be the cause: * A filtering blockage leading to poor water intake: Clean the water inlet’s filter and the water inlet. * A bent inlet hose: Replace or straighten the inlet hose. * Impurities in the water: Replace the water with clean water.
What to do if my Cecotec Pressure Washer does not absorb water?
If your Cecotec Pressure Washer is not absorbing water, check the following: * Water inlet leakage: Tighten the inlet’s joint. * Poor connection between the water inlet and its connector: Reassemble the inlet and outlet accessories. * Incorrectly assembled water inlet filter: Assemble it correctly.
Why can't I charge my Cecotec Pressure Washer battery?
If you're having trouble charging the battery of your Cecotec Pressure Washer, first, make sure the charger and the battery are compatible. Also, the battery can only be inserted into the charger in one direction, so turn the battery until it fits. The charger’s indicator light should turn red when it's charging.
Why does the charging time of my Cecotec Pressure Washer battery change?
The charging time of your Cecotec Pressure Washer's battery can vary. If the battery is only partially discharged, it will take less time to recharge. Lower battery or room temperatures can also extend charging times. If the battery gets too hot, the overheating protection system may disconnect it. If this occurs, unplug both the device and battery, let them cool, and then try charging again.
What does it mean when the ECO indicator light flashes on my Cecotec Pressure Washer?
If the ECO indicator light on your Cecotec Pressure Washer is flashing, it indicates a low battery. Charge the battery to resolve this issue.
General| Brand | cecotec |
|---|---|
| Model | HYDROBOOST 10200 LIBERTY PRO |
| Category | Pressure Washer |
| Language | English |
To Next Page
