7. CLEANING AND MAINTENANCE
1. Turn off and unplug the milk frother.
2. Remove the jug from the heating base.
3. Separate the silicone ring and the lid from the jug.
4. Clean the jug with warm water a soap. This should be done immediately after each use.
5. Rinse the lid and silicone ring in warm water. Clean with soap if necessary.
6. Wash the whisks with warm water a soap and dry them thoroughly.
7. Store the product and the whisks in a safe place.
WARNING: never use harsh or abrasive cleaning agents or cloths/pads to clean or dry the milk
frother.
WARNING: the milk frother is not dishwasher safe.
8. TROUBLESHOOTING
Issue Cause Solution
The indicator light
or jug does not
work.
The plug is not inserted properly. Insert plug again.
The jug is not connected to the
power base properly.
Remove jug and replace
correctly.
There is a problem with the
power supply.
Check the electric circuit.
The jug does
not work after
operating.
The jug temperature is too high.
Rinse the jug with cold water
to reduce temperature.
The jug is damaged because it
has been immersed in water.
Repair or replace.
The motor does
not work.
The jug has not been cleaned
properly after each use.
Clean and move the motor’s
shaft with your hand to
loosen and unblock it.
The motor is damaged. Repair or replace.
The appliance
does not heat up.
The machine is damaged. Repair or replace.
21
POWER LATTE SPUME 4000
To Next Page
Loading...
