cecotec POWER TITANIUM 300 - Parts and Components; Before Use; Operation

POWER TITANIUM 300 _ POWER TITANIUM 300 EASYGO
35
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Leak-proof cap
2. Cup
3. Blade assembly
4. Blender base
5. Power button
6. Power cable
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the ocial Cecotec Technical Support Service
immediately.
Box content
Depending on the product purchased, the contents of the box will vary.
- For the Power Titanium 300 model, in the box you will nd the blender with its cup and
blade assembly, as well as this instruction manual.
- For the Power Titanium 300 EasyGo model, you will nd the same contents as for the
previous model, but with an extra cup and two cooling tubes.
3. OPERATION
1. Place the cup on a at surface. Next, add the desired ingredients into the cup up to the
MAX mark.
2. Connect the blade assembly to the cup opening. Turn the cup upside down and place it
in the blender base using the arrows as a guide. Press the cup against the base. With a