READYWARM 2000 MAX BOX CERAMIC
41
4. Press the button a third time to switch to Standby mode, the display will show “--” as in
gure 7, B. The fan will run for 30 seconds before entering Standby mode.
5. The function of the button is the same as that of the control panel.
Setting the TIME/DAY
You can set the time and day both in standby mode and in operation.
1. Press the button , the display will show “12” by default, press the / buttons to
set the current time (00 to 23).
2. Press the button again, the display will show “30” by default. Press the / buttons
to set the minutes “00 to 59”.
3. Press the button again to display the day of the week and press / to select the
current day. Note that the following codes will be displayed:
d1 = Monday
d2= Tuesday
d3 = Wednesday
d4 = Thursday
d5 = Friday
d6 = Saturday
d7 = Sunday
4. Press to conrm the settings. Once conrmed, the previous screen will be displayed
again.
In Figure 8, you can see how the display would look at each step if the setting was for a
Wednesday at 9:30 AM.
Note:
- After switching o the device, it is necessary to reset it. Press the button to check the
current time and day.
- The time setting range is 00-23 hours, 00-59 minutes. To check the current time and set
temperature, press again.
Temperature settings
1. During operation, to set the desired temperature, press the / buttons. The display
will show “23” by default. The temperature range you can set is 10-49 ºC.
2. Press to conrm the desired temperature.
When setting the temperature, the appliance will operate as follows:
- If the temperature setting is more than 2°C higher than the room temperature, the heater
will operate in high power mode.
- If the temperature setting is equal to or 2°C higher than the room temperature, the heater
will operate in medium power mode.
08281_READYWARM 2000 MAX BOX CERAMIC_RP_01230626.indd 4108281_READYWARM 2000 MAX BOX CERAMIC_RP_01230626.indd 41 27/6/23 13:0727/6/23 13:07
To Next Page
Loading...
