READYWARM 2000 MAX BOX CERAMIC
42
- If the temperature setting is the same as the room temperature, the fan will run for 30
seconds to blow out the remaining hot air inside and the appliance will stop operating.
- If you want to cancel the temperature setting, press the button to choose medium
or high-power mode. The appliance will operate without temperature adjustment. The
temperature indicator will go out and the display will show “--”.
- After operating continuously for 12 hours, the Fan mode will be activated for 30 seconds,
and the device will enter Standby mode.
Setting up a weekly programme
Once the current TIME/DAY setting is complete, follow the steps below to set up a weekly
schedule:
1. Press the button to turn the appliance on.
2. Press the button , the icon will light up on the display .
3. Press the button and the display will show d1. Press the button again until you
select the day (Monday to Sunday: d1~d7) you want to set.
4. Press the button and the display will show P1 as the default. Press the button again
to set the time period (P1-P6).
Please note
You can only set a maximum of 6 time periods for each day. Follow steps 5-7 below to set the
desired On/O Time/Temperature for each time period (P1-P6).
1. Press the button and the display will show “00”. Press the button again, the time will
increase in one-hour intervals with each press (00-24 hours).
2. Press the button and the display will show by default the previous power-on time. Press
the button , the time will increase in one hour intervals with each press (00-24 hours).
The setting of may not be less than . If the setting of is the same as , the device will enter
Standby mode.
3. Press the / buttons to set the desired temperature (the available temperature
range is 10-49 °C).
4. Repeat steps 3-7 above, to set the weekly programme for the desired days.
5. Press to conrm the settings.
6. To cancel the weekly programme setting, press the button again and the icon will
turn o. The weekly programme will be cancelled.
In gure 9, you can see how the display would look like in the above steps if you wanted to
program the heater on a Monday, in the rst period, to turn on at 7:00 AM and turn o at
13:00 PM.
Please note
When the above settings are completed and the programme is running, press the button
to check the set day (d1-d7), press the button to check the set time period (P1-P6), press
08281_READYWARM 2000 MAX BOX CERAMIC_RP_01230626.indd 4208281_READYWARM 2000 MAX BOX CERAMIC_RP_01230626.indd 42 27/6/23 13:0727/6/23 13:07
To Next Page
Loading...
