2322
READY WARM 6400 CERAMIC SKY SMART READY WARM 6400 CERAMIC SKY SMART
Battery instructions
Keep batteries away from children and animals, they could
be deadly
if swallowed. In case of ingestion, seek medical
assistance immediately.
Should a battery have leaked, do not allow your skin, eyes or
mucous membranes to come into contact with the battery acid.
In case of contact with acid, rinse the aected areas with
abundant fresh water immediately and contact a doctor as
soon as possible.
Make sure the battery contacts in the device are clean before
inserting batteries; if they are not, clean them.
Use only the battery type specified in the technical specifications.
Always replace all the batteries at the same time. Do not use
dierent types of batteries or of dierent capacities.
When replacing batteries, note the correct polarity (+/-). Take
the batteries out of the device when they are discharged or
when the device is not going to be used in a long time. Batteries
must not be recharged or reactivated, dismantled, thrown
into fire, immersed in fluids or short-circuited.
1. PARTS AND COMPONENTS
Fig. 1
1. Screen
2. Control panel
3. Air outlet
4. Security push button
5. On/o button
6. Filter
Fig. 2
Control panel
1. Temperature button
2. Timer
3. Oscillation
4. Mode
5. On/O
Fig. 3
Remote control
1. On/O
2. Mode
3. Timer
4. Oscillation
5. On/O screen
6. Increase temperature
7. Decrease temperature
2. BEFORE USE
Take the product out of the box.
Remove all packaging material. Save the original box.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
3. OPERATION
Plug the device’s power cord into an electrical outlet.
Place the device on a rm level surface.
To Next Page