cecotec READYWARM 2050 MAX DUAL - Cleaning and Maintenance; Technical Specifications

READYWARM 2050 MAX DUALREADYWARM 2050 MAX DUAL
3332
ENGLISH ENGLISH
Thermostat regulation
Once the room has reached the desired temperature, turn the thermostat knob (if included)
anticlockwise to the point where the appliance switches o. The thermostat will automatically
regulate and keep a constant set temperature.
Protection against overheating
The heater is equipped with a safety device that will switch o the heater in case of accidental
overheating (e.g., in case of blockage of the air inlet and outlet grilles, if the motor rotates
slowly or not at all). To reset it, disconnect the power plug for a few minutes, eliminate the
cause of the overheating and plug the appliance back.
4. CLEANING AND MAINTENANCE
Always disconnect the plug from the mains supply before cleaning the appliance.
Clean the air inlet and outlet grilles frequently.
Never use abrasive powders or solvents.
WARNING! Some parts of this product may become very hot and cause burns. You must take
special care with children and vulnerable persons.
5. TECHNICAL SPECIFICATIONS
Product reference: 08283
Product: ReadyWarm 2050 Max Dual White
Voltage: 220-240 V, 50 Hz
Power: 1000 W / 2000 W
Size: W125xD240 x H235 mm
Weight: 1.05 kg
Cord length: 1,4 m
Name of the model: 08283_ReadyWarm 2050 Max Dual White
Product Symbol Value Unit Product Unit
Heating power
Type of heat input, for electrical
storage.
Local heaters only (select one)
Rated heat output P
nom
1.8 - 2.0 kW
manual control of the
heating load, with
integrated thermostat
[NO]
Minimum heat
output
(illustrative)
P
min
0.90 kW
manual control of the
heat load with feedback
of ambient and/or
outdoor temperature
[NO]
Heating power
maximum
constant
P
max,c
2.0 kW
electronic heat load
control with feedback
of ambient and/or
outdoor temperature
[NO]
Auxiliary energy
consumption
Fan assisted heat
output
[NO]
At rated heat
output
el
max
N/A kW
Type of heat output/ambient
temperature control (select one)
At minimum heat
output
el
min
N/A kW
single-stage heat
output and no ambient
temperature control
[NO]
In standby mode el
SB
0.00 kW
Two or more manual
stages, no room
temperature control
[NO]
with mechanical
thermostat for room
temperature control
[YES]
with electronic room
temperature control
[NO]
electronic room
temperature control
and daily timer
[NO]
electronic room
temperature control
and weekly timer
[NO]
Other control options (multiple
selection possible)
ambient temperature
control, with presence
detection
[NO]
room temperature
monitoring, with open
window detection
[NO]
with distance control
option
[NO]