READYWARM 6350 CERAMIC TOUCH CONNECTED
2928
1. PARTS AND COMPONENTS
Main body
Img. 1. (Page 35)
1. Control panel
2. Display
3. Air outlet
4. On/o switch
Control panel
Img. 2 (Page 35).
1. Temperature/timer +
2. Temperature/timer –
3. On/o
4. Mode
5. Oscillation
Remote control
Img. 3. (Page 36)
1. Temperature +
2. Mode
3. Timer
4. Temperature –
5. Light
6. On/o
7. Oscillation
2. BEFORE USE
Take the product out of the box.
Remove all packaging materials. Keep the original box.
Make sure all the components are included and in good conditions, otherwise, contact
immediately the ocial Technical Support Service of Cecotec.
3. OPERATION
Plug the device’s power cord into an electrical outlet.
Turn on the main switch at the back of the device.
Press the on/o button to start the heater and press the mode button to select the desired
appliance is being used by or near children.
Battery instructions
Keep batteries away from children and animals, they could
be deadly if swallowed. In case of ingestion, seek medical
assistance immediately.
Should a battery have leaked, do not allow your skin, eyes or
mucous membranes to come into contact with the battery
acid.
In case of contact with acid, rinse the aected areas with
abundant fresh water immediately and contact a doctor as
soon as possible.
Make sure the battery contacts in the device are clean before
inserting batteries; if they are not, clean them.
Use only the battery type specied in the technical
specications.
Always replace all the batteries at the same time. Do not use
dierent types of batteries or of dierent capacities.
When replacing batteries, note the correct polarity (+/-).
Take the batteries out of the device when they are discharged
or when the device is not going to be used in a long time.
Batteries must not be recharged or reactivated, dismantled,
thrown into re, immersed in uids or short-circuited.
ENGLISH
To Next Page
Loading...
