THERMOSENSE 170 35
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Jar
2. Base
3. Cable
4. Antiscale filter
2. BEFORE USE
- Before using the product for the first time, boil water twice without cleaning agents.
- Fill the jar with water without exceeding the limit, pay attention to the indicator to keep
water below the max. level.
- Place the jar on the base.
- Make sure the mains voltage matches the voltage input of the appliance.
- Press the power button to star the process.
- After boiling water, the machine switches off automatically.
- Do not open the lid when serving.
3. OPERATION
1. Before using the product for the first time, boil water twice without cleaning agents.
2. Fill the jar with water without exceeding the limit, pay attention to the indicator to keep
water below the max. level.
3. Place the jar on the base.
4. Make sure the mains voltage matches the voltage input of the appliance.
5. Press the power button to star the process.
6. After boiling water, the machine switches off automatically.
7. Do not open the lid when serving.
4. CLEANING AND MAINTENANCE
- Always disconnect the plug from the mains supply before cleaning the machine.
- The exterior of the jar can be cleaned with a slightly dampened cloth.
- In case the water used has caused minerals to build up, such as calc, it is suggested to fill
half the kettle with water and lemon juice and boil it. If impurities are still left after this,
repeat the process. Allow it to cool down before emptying and rinsing it.
01516_ThermoSense 170_IM_YV_02210217.indd 3501516_ThermoSense 170_IM_YV_02210217.indd 35 18/2/21 9:1018/2/21 9:10
To Next Page
Loading...
Need help?
General
