ENGLISH ENGLISH
14 15
ULTRAFLEX 25 ULTRAFLEX 25
chest, irregular heartbeat, extreme shortness of breath, light-headedness, dizziness or
nausea. If you experience any of these conditions, you should consult your doctor before
continuing with your exercise program.
• This product is intended for domestic use only. It is not suitable for commercial or industrial
use. Do not use it outdoors.
• Only one person at a time should use the equipment.
• Keep hands and any loose clothing or objects away from all moving parts of the product.
• Always wear appropriate workout clothing when exercising. Do not wear loose or baggy
clothing, since it may get caught in the equipment. Wear athletic shoes to protect your feet
while exercising.
• Do not place any sharp objects around the equipment.
• This product is suitable for user’s weight of up to 130 kg.
• Always use the equipment as indicated in this instruction manual. If you nd any defective
component while assembling or checking the bike, or if you hear any unusual noise coming
from the equipment during use, stop using the bike. Do not use the equipment until the
problem has been rectied. Contact the Technical Support Service of Cecotec.
• The safety level of the bike can only be maintained through regular examination for
damage and/or wear and tear signals.
• Check that the bolts and nuts are securely fastened before using the equipment.
• No liability is accepted for any eventual damage or personal injuries derived from misuse
or non-compliance with this instruction manual.
3. BEFORE USE
1. Attach the front stabilizer to the main frame using, two Ф10 spring washers, two Ф10
washers, and two dome nuts. Install the back stabilizer in the same way.
2. The pedals are marked “L” (left) or “R” (right). Insert the xing screw of the right pedal into
the crank on the right side of the product and x it with the spanner. Then, screw the nut
into the xing screw on the other side of the crank. Proceed the same way to x the left
pedal to the crank on the left side of the product.
3. Fix the handlebar to its support with the Allen screws and washers.
4. Place the handle cover onto the handle. Please press the handle cover gently lo lock it into
place.
5. Use the locking bolt to adjust the height of the handlebar as shown in the picture.
6. 1. Slide the monitor onto the grooves you can nd on its support.
2. Connect the cables to the sockets “sensor” and “pulse”
3. Keep all the cables inside the corrugated pipe.
To Next Page
Loading...
Need help?
General
