cecotec WANDERLUSTMIX USB - Cleaning and Maintenance; Troubleshooting

BATIDORA DE VASO INDIVIDUAL USB / USB SINGLE-SERVE JUG BLENDER38
ENGLISH
5. CLEANING AND MAINTENANCE
1. Detach the cup from the base.
2. Rinse the cup and the lid with water. Use a cloth to clean the blender body.
Note
Prevent water from entering the button and the USB charging port.
6. TROUBLESHOOTING
No. Problem Cause Solution
1 After installation, the blender
does not work and the red
indicator light ashes
The cup or the cup’s lid are
not xed properly.
Screw the cup into
the base by turning
it clockwise.
2 The blender does not work
and the red indicator light
lights up for 5 seconds
Not enough battery or about
to run out.
Charge the battery.
3 The blender stops
automatically when in
operation
There is not enough food,
or the blender has stopped
automatically after 45
seconds of operation.
Add ingredients
above the blade
and switch the
blender back on.
4 The red and white indicator
lights ash alternately for 10
seconds
The motor is blocked. Remove the food
blocking the blades
and switch on the
blender again.
5 Liquid spillage The silicone gasket is not
properly tted.
Install the gasket
correctly to prevent
uid spillage.
6 Smoke Due to continued use.
Protection against
overheating system is
activated.
Let the blender
stand for 30 to 60
minutes before
using it again.