3
BEFORE YOU BEGIN ASSEMBLY:
Read your instruction manual fully. Check all parts and hardware. If anything is missing or not satisfactory, please DO
NOT call the store or return the product to them. Please email to customerservice@cedargreen.net for assistance. Most
problems are resolved promptly without you needing to leave home.
Installation Steps
Using a level draw a horizontal line across back of closet, 74” above floor.
Locate studs by using a stud finder, lightly mark wall 1/4” below horizontal line to
reference stud locations.
Mark vertical panel locations: using left wall as starting point; mark X at 25” for left
Tower Panel (2); mark X at 44” for right Tower Panel (2); mark X at right end for
right Wall Panel (1).
Hint:
- 74” above floor is just a recommendation, horizontal line could be set higher (e.g. 78”) if
more hanging space is desired.
- Closet has to be at least 78” wide in order to fit all three sections of the system. Less than
three sections can be installed for smaller closet.
To Next Page
Loading...