8
Standby preservation
This machine has a standby preservation of function, no cleaning day, wash the washing machine according to a predetermined cycle. If the day is
not cleaning operations, be sure to follow the following
- - When using the manual mode standby, to ensure the machine's power supply is not interrupted
1. Check the amount of starting material remaining cylinder material, and to ensure that the liquid level above the metal probe tips off Queliao
2. canceled with a clean towel dip venom, wiping material cylinder edge, top of the machine and the inner surface of the cylinder head material
3. Close the feed head, precooling confirmation function is enabled (the lower right corner of the display lighting snowflake pattern), press the "Manual" key
Washing machine
This machine has a standby preservation of function, no cleaning day, wash the washing machine according to a predetermined cycle
- - Alternatively cleaning operation before starting the business, when the raw material is liquid refrigerant cylinder can release without thaw, save time
- - Do not pour hot water into the machine, if not dry in time, may lead to rapid propagation of bacteria hazardous to their health
1. Press the "Stop" button, the Extruded Tube with The pot stir bar Placed into a container to be washed to remove1. Press the "Stop" button, the Extruded Tube with The pot stir bar Placed into a container to be washed to remove1. Press the "Stop" button, the Extruded Tube with The pot stir bar Placed into a container to be washed to remove1. Press the "Stop" button, the Extruded Tube with The pot stir bar Placed into a container to be washed to remove1. Press the "Stop" button, the Extruded Tube with The pot stir bar Placed into a container to be washed to remove
2. Press the "clean" to start stirring, then depress the handle release of the remaining starting material
3. The amount of water was poured into the pot, the pot inner wall with a towel wiping
4. The dirty water discharged, is repeated until the rinse water discharged no turbidity
The water is bled off, press the "Stop" button, turn off the power
6. Remove Body assembly Into a container to be washed6. Remove Body assembly Into a container to be washed6. Remove Body assembly Into a container to be washed
7. Remove Agitator shaft with Countershaft Into a container to be washed7. Remove Agitator shaft with Countershaft Into a container to be washed7. Remove Agitator shaft with Countershaft Into a container to be washed7. Remove Agitator shaft with Countershaft Into a container to be washed7. Remove Agitator shaft with Countershaft Into a container to be washed
8. The dry material cylinder and cooling cylinder residual moisture
9. The cleaning various parts removed (hot water available), using the bore brush cleaning attachment is provided in the inner wall of puffing
10. The configuration about 5L disinfectant to wash the parts immersed in the disinfectant stand
11. canceled with a clean towel dip venom wiping material cylinder and cooling cylinder walls
12. The component is mounted on the machine again, to complete the cleaning
- - If not used for the washing machine, so that parts can be immersed in the disinfecting solution, kept dry and ventilated machine, installation needs to be used
To Next Page
Loading...