9
Using a USB Cable
1. Connect a computer to your device with a USB cable.
2. Power on your device. The operating system detects
and identies new hardware, and automatically installs
the hardware.
NOTE:
If the system does not automatically launch installation,
you can click the device installation icon in My Computer
to install.
3. Wait until the computer is connected to your device
successfully.
Using the WPS (Optional)
If your client device supports WPS, you don’t have to input
the password manually after WPS has been available.
Please do the following:
1. Power on your device, and enable the Wi-Fi function
on your device.
2. Press and hold the WPS button on your device about
three seconds to start Wi-Fi Protected Setup authenti-
cation process.
To Next Page
Loading...