17
Double Quantity Cooking
1) Under Ready Mode, press X2 and then press number buttons 0-9. In 5
seconds, the oven will start cooking with the quantity preset cooking time x
0.8 (default factor for X2).
2) Press X2 and doub displays in the LED. When you press the number pads,
the LED will display the quantity preset time.
Example: Pad 5 is set for 1 minute. Press X2 then pad 5 and the 1:00 (1:00 +
0.8) = 1:48
3) When the cooking program finishes, the oven will enter End Of Cook Cycle
Mode.
4) To change the X2 cook factor for a pre-program, when you pre-program the
pad, press X2 during the programming and the LED will show CF:XX (if
default it will show as CF:80). Use the number pads to change the default
number and save along with the program. This will change the cook factor
for this pad only.
Stage Cooking Programming
This allows the user to cook food items in a combination of various Power levels
on 1 pad.
1) Three (3) stages can be set under cooking mode or in program mode. Total
time of the 3 stages cannot exceed the maximum cook time allowed per
pad.
2) After setting the time and power level for Stage 1, press Time Entry to get
to Stage 2, and the same to get to Stage 3, setting time and power level for
each stage.
3) When you press Time Entry S2 or S3 will display in the LED.
4) If in manual mode, press Start to start cooking. If in program mode, press
Start to lock in the program.
5) The LED will show the total time of the 3 stages in the display when the
program is started.
To Next Page
Loading...