Celestron Regal M2 - Cleaning Optics; Service and Repair

5. Do not leave the spotting scope in a car on a hot/sunny day or near anything that generates heat as this
may cause damage.
6. Clean any dust, dirt or water that may get on the spotting scope or inside moving parts as soon as possible
to prevent any unforeseen damage.
CLEANING
Proper lens cleaning is essential to maintaining the optical integrity of your spotting scope. Dirty lenses diminish
the amount of light transmitted through the spotting scope and your overall viewing experience .
1.
Remove any dust on the lenses with a soft lens brush or can of pressurized air.
2.
Remove any fingerprints, stains or smudges from the lens surface with a soft, clean lens cloth or lens tissue
by rubbing in a circular motion. Start in the middle of the lens and work your way to the edges. Breathe
lightly on the lens to provide moisture if needed.
3. For a more thorough cleaning we recommend the use of a lens/optics cleaning kit available at most photo
or optical shops. Follow the directions supplied with the cleaning kit for best results.
SERVICE AND REPAIR
If warranty problems arise or repairs are n .:ontact the Celestron customer service department if you live
in
the United States or Canada. If you live outside of these countries, please contact the dealer you purchased
your spotting scope from or the Celestron distributor in your country. A list of our distributors can be found on
our website.
9