EasyManua.ls Logo

CellarPro 3200VSi-ECX - Page 20

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20V3.15.22
III.OperatingInstructions
Overview
Testthecoolingunittomakesureitisworkingproperlybeforeinstallingthecoolingunit(referto
theinstructionsatthebeginningofthepreviouschapter.)
CellarPro cooling units are designed to maintain optimal conditions for wine storage and aging.
Theseconditionsincludesteady,cooltemperatures,highhumidity,minimalvibrationandlight,and
cleanair.
ThesettingsonyourCellarProcoolingunithavebeenpresetandoptimizedbythefactory.Before
changinganysettingsbelow,werecommendwaiting14daystoallowthecoolingunitto“breakin.”
Thecoolingunitisdesignedtocoolthecellargentlywithoutstrippingmoistureoutofthecellar
environment.Therefore,itisnotuncommonforthecoolingunittorunnonstopforuptoaweek
initially,dependingonthetemperatureinsidethecellar,thesizeofthecellar,andthetemperature
oftheambientenvironment.Oncethecellarhasreachedequilibrium,itisnormalforthecooling
unittorunasmuchas75percentofthetime.
CellarProcoolingunitsaredesignedtomaintainoptimaltemperaturesforstoringandagingfine
wine.CellarProcoolingunitsarenotdesignedtomaintaintemperaturesforservingwine,which
tendtobemuchcolderthanstoragetemperatures,especiallyservingtemperaturesforwhiteand
sparklingwines.
CellarProcoolingunitsmustbeused,stored,movedand/orshippedintheuprightposition.Be
carefulwhenturningtheunitonitsside.TheunitNEVERshouldbeturnedupsidedown.
The cooling system is programmed with a 3‐Minute Delay at Startup to protect its internal
components.
TemperatureControl
CellarPro cooling units are designed to turn “on” when the air temperature passing over the
evaporator coils inside the cellar exceeds the Minimum Set Point plus the Temperature
Differential, and turn “off” when the temperature drops below the Minimum Set Point. For
example,iftheMinimumSetPointis58
°
FandtheTemperatureDifferentialis4
°
F,thecoolingunit
willturnonwhenthetemperaturerisesabove62
°
Finsidethecellar,anditwillturnoffwhenthe
temperaturefallsbelow58
°
F.Inthisexample,theaveragetemperatureinsidethecellarwillbe
60
°
F.
BasicOperation
ThetemperatureinsidethecellarcanbeincreasedordecreasedbychangingtheMinimumSet
Pointassummarizedbelow,anddetailedlaterinthischapter.
• Pressthe“Set”buttonforthreesecondsuntilthesnowflakeor°Fblinks
• Press“Up”or“Down”button

Related product manuals