Cellink BIO X6 - Page 141

BIO X6 User Manual v. 1.0 141
does not reach set
temperature.
on the chamber fan to faster reduce
the temperature of the BIO X6. Place
the BIO X6 in a cool room.
Thermoplastic
Printhead is clogged.
Material is blocking
the tip.
Clean the printhead by following
the instructions in the Thermoplastic
Printhead Manual.
Printer cannot read
USB flash drive.
USB malfunction.
Try a different USB.
Ensure you have selected Safely
Remove Hardware on your computer
before removing the USB flash drive.
USB file does not
appear.
USB file error.
Try a different USB.
Format the USB flash drive.
Redownload files to the USB flash
drive.
UV lights
not triggered.
Door is open.
Close the door.
Pump noise does not
stop
Pump not reaching
the pressure
Low air tank
pressure detected
while extruding
The pump is
disabled after 15
seconds of
continuous work
Check the air connections to printhead
Restarting the printer will re-enable
the pump
Re-enable the pump, if error persist,
contact support
ABL Automatic bed
levelling fails.
The surface where
the print is going to