Cello Encore Amplifier - Electrical Specifications

ENCORE TRUE DUAL
MONO AMPLIFIER
Electrical Specifications
ENCORE AMPLIFIER
Power Output
Single Amp Rated
I MP (Ohms) Watts (RMS)
8
50
4
100
Bridged Set
I MP (Ohms) Watts (RMS)
8 200
I MD SMPTE
60Hz & 7kHz
20V ouput
.................................................................
3%
THD
20Hz - 20kHz
8 Ohms 20V output
...............................................
<0.3%
4 Ohms 20V output<0.3%
Frequency Response
20kHz
..................................................................
-0 .3d B
100kHz
.................................................................
-6.0dB
Channel Separation
L-R
.....................................................................
Infinite
Signal to noise
20V output
1kHz
.................................................................
<-100dB
Input Impedance
Non-inverting
...............................................
330kOhms
Inverting
...........................................................
5kOhms
Input Sensitivity
20V output, 8 Ohms
50W (RMS)
..........................................................
1.485V
Gain
......................................................
28.5dB unbalanced
34.5dB balanced
NOTE: All measurements are for one mono amp unless otherwise indicated.
(All specifications subject to change without notice.)
7