Celsi Electriflame - Fixing The Facia

D. Fixing The Facia
1. On each side of the fire there are one locating stud on the upper part of the side and
one screw hole on the lower part of the side (Figure 5).
2. On the back of the facia there are two brackets which hook over these studs.
3. Lift the facia up to the fire. Two people may be required to carry out this installation.
Then lower the facia into place so that the brackets on the rear of the facia locate either
side of the studs on the upper part of each side of the fire. Then screw the lower part of
the bracket into the screw holes on each lower part of the engine’s side. (Figure 6)
THE INSTALLER SHOULD EXPLAIN TO THE CUSTOMER FULLY HOW TO
OPERATE THE APPLIANCE.