Celsius CDW12 - Cleaning the Door; How to Keep the Dishwasher in Shape; Electrical Requirements; Electrical Connection

8
Never use a s
p
ra
y
cleaner to clean the door
p
anel for it could dama
g
e the door lock and electrical com
p
onents. It is not allowed
to use the abrasive agent or some paper towel becauseof the risk of scratching or leaving spots on the stainless steel surface.
To clean the ed
g
e around the door,
y
ou should use onl
y
a soft warm, dam
p
ra
g
. To
p
revent
p
enetration of water into the door lock and electrical com
p
onents, do not use a s
p
ra
y
cleaner
of any kind.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finish. Some papers towels can also scratch or leave marks on the surface.
After every wash, turn off the water supply to the
appliance and leave the door slightly ajar so that
moisture and odors are not trapped inside.
Before cleaning or performing maintenance, always
remove the plug from the socket. Do not run risks.
To clean the exterior and rubber
p
arts of the dishwasher,
do not use solvents or abrasive cleaning products.
Rather, use only a cloth and warm soapy water.
To remove spots or stains from the surface of the
interior, use a cloth dampened with water and a little
white vinegar, or a cleaning product made specifically
for dishwashers.
When
y
ou
g
o on holida
y
, it is recommened that
y
ou run a
wash cycle with the dishwasher empty and then remove
the
p
lu
g
from the socket, turn off the water su
pp
l
y
and
leave the door of the a
pp
liance sli
g
htl
y
a
j
ar. This will hel
p
the seals last longer and prevent odors from forming
within the appliance.
If the a
pp
liance must be moved, tr
y
to kee
p
it in the vertical
position.If absolutely necessary, it can be positioned on
its back.
One of the factors that cause odors to form in the
dishwasher is food that remains tra
pp
ed in the seals.
Periodic cleanin
g
with a dam
p
s
p
on
g
e will
p
revent this
from occurring.
This dishwasher is desi
g
ned for o
p
eration on an ade
q
uatel
y
wired individual 220~240VAC,50~60HZ. Use re
q
uired fuse 10 am
p
.
Fused electrical supply is required-copper wire only. Time delay fuse or circuit breaker recommended and provide separate
circuit serving only this appliance. Outlet should be placed in adjacent cabinet.
After making sure that the voltage and the frequency values for the current in the home
correspond to those on the rating plate and that the electrical system is sized for the
maximum voltage on the rating plate, insert the plug into an electrical socket which is
earthed properly. If the electrical socket to which the appliance must be connected is not
appropriate for the , replace the socket,rather than using a adaptors or the like as
they could cause overheating and burns.
plug