SKU 98025 For technical questions, please call 1-800-444-3353. Page 7
Plug the red Test Lead into the VWmA 3.
(Center) Jack. Plug the black Test
Lead into the Com (Bottom) Jack.
Switch the Multimeter ON.
Connect the red probe to the positive 4.
terminal of the battery and the black
to the negative terminal.
The battery amperage under a load of 5.
370 mW will be displayed to a resolu-
tion of .1mA.
Normal amperage: 6.
For a standard 9V (6LR61) battery =
25 mA
For a 1.5 V “AA” (LR6) battery = 4 mA7.
To prevent accidents, turn off the 8.
tool and disconnect its power supply
after use. Clean, then store the tool
indoors out of children’s reach.User-
Maintenance Instructions
Proceduresnotspecically
explained in this manual must
beperformedonlybyaqualied
technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
remove the test leads before
performing any inspection,
maintenance, or cleaning
procedures.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
AFTER USE,2. clean external surfaces
of the tool with clean cloth.
Replace battery as necessary. 3.
No replaceable parts. 4.
To Next Page
Loading...
Need help?
General
