Need help?Do you have a question about the Cen GST 7.7 and is the answer not in the manual?
Assembling the core components of the center differential.
Attaching gear to differential case with gasket and shim.
Attaching gear assembly to diff case and inserting lock block.
Assembling the forward/reverse shifter mechanism.
Inserting pin and securing external shift unit with T-bolt.
Installing bevel gears and gear supports into differential housing.
Assembling center lock with bearing, shaft, and pin.
Installing the shift assembly onto the main shaft.
Assembling the outdrive barrel, telescope shaft, and securing with clips.
Filling differential case with grease for lubrication.
Assembling the 3-speed internal expanding clutch.
Assembling the 1st shaft unit with gear and bearing.
Inserting bearing, output shaft, and pin into gear.
Assembling the internal shifter components.
Assembling the center transmission halves.
Assembling ring gear, outdrive, and bevel gear.
Attaching bevel gear assembly to differential case.
Installing bevel gears and supports into differential housing.
Filling differential with silicon fluid.
Assembling differential case cover with outdrive and pin.
Assembling differential with gasket, shim, and screws.
Mounting the engine to the engine mount.
Installing copper shim, drive cone, and flywheel.
Assembling clutch shoes with springs and flywheel.
Installing shims and threading clutch bell onto crankshaft.
Pressing bearings into clutch bell and securing with screw.
Assembling muffler pipe, nipple, and screws.
Assembling linkage components and securing brake levers.
Mounting engine and setting gear mesh.
Installing shims for proper gear alignment and mesh.
Adjusting screws for the 2nd speed transmission shift point.
General| Brand | Cen |
|---|---|
| Model | GST 7.7 |
| Category | Motorized Toy Car |
| Language | English |
To Next Page
