6
3 Before use
3 Before use
3.1 Unpacking
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact.
3.2 Selecting the proper nozzle
1. Select the nozzle according to the surface to be cleaned:
Floor nozzle (Fig. 2/1):
It can be used everywhere and, thanks to its switch, can be used equally
well on carpets and hard floors.
Parquet brush (Fig. 2/2):
Its long bristles make it especially suitable for cleaning delicate surfaces
(e.g. parquet and laminate floors).
Turbo brush (Fig. 2/3:
This has a rotating brush head and is most suitable for deep cleaning
carpets thoroughly. The brushing action also raises the carpet pile.
Crevice nozzle (Fig. 2/4):
Use these accessories to vacuum dust from narrow, hard-to-reach places.
Furniture brush (Fig. 2/5:
Use this to vacuum dust off objects that have sensitive surfaces.
2. Push the accessory bracket onto the telescopic tube as shown, or onto
the handle (Fig. 3/A).
3. Push nozzles not in use onto the stubs of the accessory bracket (Fig. 3/
B).
4. Keep the other nozzles safe and inaccessible to children.
3.3 Assembly
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or of the handle (Fig. 4/B1).
2. Insert the end of the suction hose into the intake opening (Fig. 5/A) of
the vacuum cleaner until you hear and feel it locking into place.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the
release latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage. Keep the packaging for such an event. However, dispose of no
longer needed packaging material properly.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
2
3
4 5
1
2
BA
3
B
A
1
1
4
B
C
A
5
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not
connected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
To Next Page
Loading...