23
USING THE ATTACHMENTS
HAIR TRIMMING ATTACHMENT
1. Clip the hair trimming attachment on the trimmer body.
2. The device comes with 4 auxiliary attachments with different cut length
(3, 6, 9 and 12 mm). Install the desired attachment.
3. Press the activation button.
4. Proceed with hair trimming.
SHAVER ATTACHMENT
1. Clip the shaver attachment on the trimmer body.
2. Press the activation button.
3. Proceed with shaving. (Attention: the shaver attachment is only
designed for face and neck shaving.)
Attention: do not press the shaver attachment too hard to your skin while
shaving – This may damage the mesh of the shaver or harm yourskin (e.g.
burning sensation, numbing or pain).
NOSE AND EAR HAIR TRIMMER ATTACHMENT
1. Clip the nose and ear hair trimmer attachment on the trimmer body.
2. Press the activation button.
3. Place the tip of the trimmer in your nostril. Make circular movements
taking the attachment in and out. Use the attachment to trim the hair
in the nose, ears and for eyebrow trimming (to straighten the eyebrow
outlines). Cutting eyebrows with the attachment is not recommended.
Note: Ensure that the nasal cavities are clean before using the attachment.
Please do not insert the tip of the trimmerinto yournostrils deeper than 0.5 cm.
STYLER ATTACHMENT
1. Clip the styler attachment on the trimmer body.
2. Press the activation button.
3. Proceed with beard modeling or haircut outlining.
5. MAINTENANCE
ATTENTION!
1. Ensure that the device is turned off and the power cable is disconnected
from the electric socket.
2. Wipe the body of the device with a damp cloth. Take care that moisture
does not penetrate into the device’s housing.
3. Do not use abrasive agents or solvents for cleaning the device.
4. Do not clean the device by submersing it in water.
CLEANING THE HAIR TRIMMING ATTACMENT
1. Press the latch on the top of the paddle and detach the blade from the
attachment head.
2. Use the brush to clean the hair trimming attachment.
3. Reinstall the blade into the attachment head and drop a little oil on
the blade.
CLEANING THE SHAVER ATTACHMENT
1. Remove the shaver head from the shaver attachment by pressing the
two buttons on the sides of the shaver head base.
2. Shake the shaver head to free it from hairs.
3.Clean out the remaining hairs with the brush.
4. Put the shaver attachment back on until you hear a click.
CLEANING THE NOSE AND EAR HAIR TRIMMER ATTACHMENT
Use the brush to clean the nose and ear hair trimmer attachment. Please
insert the body of the trimmer and the accessories into the charger
stand after cleaning to protect it from damage and to prevent loss of the
accessories.
To Next Page
Loading...