9
4.
Disconnect the iron from the electric power grid before filling the
water tank.
5.
If the power cable should be damaged, have it replaced by the
Manufacturer, authorized service centre or similar skilled personnel
to avoid dangerous situations.
6. Do not use the appliance if the power cable or plug is damaged.
7. Do not submerge the appliance in water.
8. Do not allow the power cable to contact the hot sole of the appliance.
9.
Prior to putting the appliance away for storage let it cool down
completely.
10. Use and store the appliance on a stable surface.
11.
Do not operate the appliance if it has been dropped, has visible damage
or leaks water.
12.
Do not connect the appliance to power supply via a timer or other
remote control device.
13.
The surface of the heating element will remain hot for some time after
the appliance is turned off.
14.
Accessible surfaces of the appliance can become very hot during
operation.
15. Special instructions for transportation (shipment) and sale: none.
16. Should You decide to transfer the appliance to another person, please
pass the present manual over along with it.
ATTENTION! Before first use, try the iron out on a useless piece of fabric to
ensure that the sole or the water tank is not contaminated. Some parts
of the appliance are slightly lubricated during assembly; therefore some
smoke can occur when the iron is turned on for the first time. This should
disappear within a few seconds.
2. APPLIANCE DESCRIPTION
1. Sprayer
2. Filler neck
3. Steam regulator
4. Steam shock button
5. Spray button
6. Indicator
7. Self-cleaning button
8. Temperature controller
9. Ceramic Iron Sole
3. COMPLETENESS
- Iron - 1 pc.
- Measuring cup - 1 pc.
- User manual - 1 pc.
4. WORKING PROCEDURE
Remove the protective film/cardboard from the sole of the iron. The steam
iron can use ordinary tap water. If the hardness of tap water exceeds 17° dH,
it is necessary to use distilled or demineralized (filtered) water to increase
the service life of the iron. Fill the water tank (for steam ironing). Disconnect
the iron from the mains and set the steam supply switch to the «0» position.
Fill in the water so that its level is visible approximately in the middle of
the transparent part of the iron body. Plug the iron into an electrical outlet.
TEMPERATURE CONTROL
Sort the laundry according to the composition of the fabrics and the
appropriate ironing temperature. Iron products that require a lower
temperature first, since the iron heats up faster than it cools down.
The indicator lamp signals the heating of the iron. Turning off the lamp
indicates that the iron has reached the set temperature and You can start
ironing.
FUNCTIONS
SPRAYER
To spray water on the fabric, press the «Spray» button.
DRY IRONING/STEAM
The steam supply intensity can be changed using the steam supply
regulator. In the position, the steam supply is turned off (dry ironing).
STEAM STROKE
To use the steam shock function (powerful one-time steam emission), press
the «Steam Shock» button.
ATTENTION! Use the «Steam blow» button only after the iron is heated to
the steam production temperature. Do not press the steam shock button
more than three times in a row.
In order for the iron to heat up again, simply lift or move the appliance
slightly. The auto power off indicator will stop flashing. Instead, the heating
indicator will light up. The iron is ready for use again.
5. CARE OF THE DEVICE
Set the temperature controller to the OFF position and disconnect the
iron from the mains. Place the iron in an upright position and let it cool
completely. Drain the water from the iron container. Set the steam supply
regulator to the position. Remove deposits from the sole of the iron with a
solution of acetic acid. Wipe the iron body with a damp cloth, then wipe dry.
To Next Page
Loading...