All-In-One Laser Boresighter
Model – CPLBS1745
CenterPoint Hunting and Outdoors • 7629 Routes 5 & 20 • Bloomeld, NY 14469 • www.centerpointoptics.com
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS LASER BORESIGHTER.
BUYER AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF THIS LASER BORESIGHTER.
CAUTION: Before boresighting in your rearm, ALWAYS make sure your rearm is unloaded, on safe and pointed in a SAFE DIRECTION.
CAUTION: After your rearm is boresighted, ALWAYS be sure to remove BOTH the boresighter and adapter from your gun.
CAUTION: AVOID DIRECT EYE EXPOSURE. Laser emitted from the aperture.
CAUTION: A laser sight is not a toy. It must be used under the supervision of an adult. Improper use or careless use may cause serious injury, especially to the eyes. Avoid
direct eye exposure to the laser beam.
CAUTION: Use of controls or adjustments or performance of procedures other than those specied herein may result in hazardous radiation exposure.
Always follow the safety instructions found in the owner’s manual and keep these instructions in a safe place for future use.
For your convenience and safety, the following label is on your laser:
This product complies with 21CFR Subchapter J Parts 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50 dated June 24, 2007. Complies with IEC/EN
60825-1:2007 Ed. 2.
A. .17 Cal.
B. .220–.250 Cal. 5.45 x 39 mm
C. .270–.320 Cal., 7 mm, 7.62 x 39 mm, 7.62 x 54 mm, .30–06, .30–30
D. .338–.357 Cal., 9 mm
E. .440–.50 Cal.
F. 12 Ga., 16 Ga., 20 Ga.
1. Battery Installation
A. Parts
LR44 Batteries
Battery Holder
Bore Sight
B. Installation
Fig. 2
Fig. 1
1. The battery holder also rotates to turn the laser on/o. In order to remove the battery holder to change/install the batteries, the laser must be in the “ON”
position (Fig. 1).
2. Lift up on batter holder and pull battery holder out of the boresighter.
3. Insert three LR44 batteries (included) into the battery holder with the negative side facing out of the holder.
4. After the batteries are installed into the battery holder insert the holder into the bore sight body open end rst with index tab up (Fig. 2).
5. Turn the battery holder to the “OFF” position until ready to use.
POINT THE LASER SIGHT IN A SAFE DIRECTION AT ALL TIMES. AVOID DIRECT EYE EXPOSURE.
2. Directions for Use
1.
Make sure your rearm is UNLOADED, ON SAFE, and pointed in a SAFE DIRECTION.
2. Choose the adapter that most closely ts your barrel bore size and thread adapter onto the boresighter (Fig. 3).
Fig. 3
3.
Insert boresighter into barrel and turn the boresighter counter-clockwise until the boresighter ts snug inside the barrel (Fig. 4).
Fig. 4
4. Turn boresighter on (Fig. 5).
5. Sight in. Shine the laser onto a target 25 yards away. Adjust the scope or sight’s windage and elevation dials until the laser dot matches up with the center of the
crosshairs or sight. If sighting in at a shorter distance (i.e. at 10yds) adjust the crosshairs approximately 2inches above the red laser dot (Fig. 6).
25 yds
Fig. 5 Fig. 6
6.
Remove boresighter. Make nal adjustments with ammunition.
CAUTION: After your rearm is boresighted, ALWAYS be sure to remove BOTH the boresighter and adapter from your gun.
SPECIFICATIONS
Output Power Class 3R, <5mW Visibility
Rate 100 yds at night;
25 yds in daylight
Batteries (3) LR44 Button Cell Batteries
Wavelength 630-670 nm Barrel Requirement Minimum 3.8” barrel Warranty 1 year
LIMITED ONE YEAR WARRANTY
Your CenterPoint
®
boresighter is warranted to the retail consumer for one year from date of retail purchase against defects in material and workmanship and is transferable.
You should retain the original sales receipt as record of date of purchase. If no receipt, the product is warranted for one year from date of manufacture.
This warranty does not cover damages due to fair wear and tear, failure to provide routine maintenance, and does not include batteries or accessories. In the event of a defect
under this warranty, we will, at our option, repair or replace the product; provided, however, our inspection indicates that an original defect exists. CenterPoint reserves the
right to replace any product which is no longer available with a product of comparable value and function. If CenterPoint determines the repair is not covered under the
warranty guidelines, there could be a charge to you for the repair. This is a limited warranty and does not cover damages caused by misuse, improper handling or installation
or maintenance provided by someone other than a CenterPoint Authorized Service Station.
This limited warranty does not include consequential damages, incidental damages, or incidental expenses, including damage to property or any other expense. CenterPoint
disclaims any implied warranties, including the implied warranties of merchantability and tness. Some states do not allow the exclusion or limitation of incidental or
consequential damages, or allow limitations on implied warranties so the above limitations or exclusions may not apply to you. To the extent any provision of this warranty is
prohibited by federal, state or municipal law, which cannot be preempted, it shall not be applicable. This warranty gives you specic legal rights, and you may also have other
rights, which vary from state to state and country to country.
STOP – BEFORE YOU RETURN THIS PRODUCT TO THE STORE
Save on gas and avoid the trip back to the store. Contact our Customer Service/Technical Support representatives for information and trouble-shooting help at
1-800-726-1122 or visit our web site at centerpointoptics.com.
WARRANTY CLAIMS/ REPAIR SERVICE
If your product needs repair, DO NOT ATTEMPT TO DISASSEMBLE IT! Any disassembly or modication not performed by a CenterPoint Authorized Service Station will void the
warranty.
U.S. Customers - Contact CenterPoint Customer Service -1-800-726-1122 or email us at centerpointoptics.com. You will be instructed where and how to send your
CenterPoint product in for repair/replacement under warranty or referred to one of our authorized service centers in your area.
CenterPoint Precision Optics
Crosman Corporation
Attn: Warranty Dept.
7629 Route 5 & 20
Bloomeld, NY 14469
Include with your product a copy of your receipt and a brief description of the problem. Be sure to indicate your name, mailing address, email address and telephone number.
Allow 2-4 weeks for product repair/replacement. We recommend you use a method of shipping that provides you with a tracking number and insurance options. CenterPoint
is not liable for any merchandise damaged, lost or stolen during shipping to and from CenterPoint.
Canadian Customers - Contact the Gravel Agency, in Quebec at 866- 662-4869.
Outside U.S. Customers: Please contact your point of purchase dealer/distributor. If you do not know your dealer/distributor, contact our International Dept. for assistance
at 585-657-6161 or email us at centerpointoptics.com.
CenterPoint is a trademark of Crosman Corporation.
© 2016 Crosman Corporation
OM 1-16
CPLBS1745D515
To Next Page
Need help?
General