Centork 482 Series - User Manual

Centork quarter-turn
electric actuators series 480
centronik units with Profibus DP
Installation and maintenance
user manual

Summary

CENTORK ELECTRIC ACTUATORS: INTRODUCTION

SAFETY INSTRUCTIONS

Crucial safety guidelines for operating Centork actuators.

TRANSPORT AND STORAGE

3.2 Storage and commissioning

CONDITIONS OF SERVICE FOR ELECTRIC ACTUATORS

4.2 Operation modes: OFF, LOCAL and REMOTE mode

ABOUT PROFIBUS-DP

5.1 General description

5.3 Technical features for PROFIBUS-DP

Summary of technical specifications for the PROFIBUS-DP system.

CENTORK PROFIBUS-DP INTERFACE OVERVIEW

MOUNTING TO THE VALVE

7.2 ACTUATOR MOUNTING

ELECTRICAL CONNECTIONS

8.1 Wiring diagram (electric manoeuvre)

8.2 Terminal plan and wiring

PRELIMINARY TEST AND SETTINGS

9.1 Handwheel and Declutching

9.2 DIP-SWITCHES configuration

Specific settings for DIP switches to configure actuator operation modes.

9.3 Mechanical Travel Stop Adjustment

Adjusting the mechanical limits for valve travel to prevent over-travel.

9.9 CENTRONIK setting procedure

Comprehensive guide to configuring the Centronik unit's parameters.

9.10 LOCAL mode: Control and displays elements

Description of local control interface elements and status indicators.

FIELDBUS CONFIGURATION

10.1 Fieldbus Connector

10.2 Configuration

Steps and considerations for configuring the PROFIBUS-DP interface.

FIELDBUS PROGRAMMING

11.1 MODULATING CENTRONIK units

Describes data exchange for modulating units via PROFIBUS-DP.

11.2 ON;OFF with position display CENTRONIK units

11.3 ON;OFF CENTRONIK units

TROUBLE SHOOTING

12.1 Front panel indication fault

12.6 Fieldbus communication

Troubleshooting PROFIBUS-DP communication problems.

MAINTENANCE

13.2 Maintenance for service

13.4 Fuse replacement

TECHNICAL SUPPORT

WIRING DIAGRAMS, TERMINAL PLANS, LEGENDS AND SYMBOLS

Centork 482 Series Specifications

General

Brand	Centork
Model	482 Series
Category	Controller
Language	English