Central Pneumatic 52847 User Manual

AIR DIE GRINDER
REAR EXHAUST
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
For technical questions please call 1-800-444-3353
Manual Revised 11h
Copyright © 2001 by Harbor Freight Tools
®
. All rights reserved. No por-
tion of this manual or any artwork contained herein may be reproduced in any
shape or form without the express written consent of Harbor Freight Tools.
Operating and Maintenance Instructions
Model #52847

Central Pneumatic 52847 Specifications

General

Type	Angle Grinder
Arbor Size	5/8 inches
Speed	11, 000 RPM
Amperage	6 amps
Voltage	120V
Length	12 inches
Disc Diameter	4.5 inches
Wheel Thickness	0.25 inches

Summary

Safety Warnings and Precautions

Keep Work Area Clean and Dry

Keep Children Away From Work Area

Do Not Use Under Influence of Alcohol or Drugs

Avoid operating the tool if judgment or reflexes may be impaired by alcohol or drugs.

Use Eye and Hearing Protection

Always wear ANSI-approved safety impact eye glasses and hearing protection while operating the tool.

Check For Damaged Parts

Specific Product Warnings and Precautions

Use Clean, Dry, Regulated Compressed Air at 90 PSI

Operate the tool only with clean, dry, regulated compressed air at 90 PSI; do not exceed this pressure.

Connecting to Air Supply

Disconnect Tool Before Servicing

Always disconnect the tool from the air supply and release pressure before any servicing or maintenance.

Chemical Exposure Warning

Operating Instructions

Connect Air Hose

Attach a 1/4" NPT Quick Connector to the air inlet and connect the air hose.

Insert/Change Collets

Instructions for removing, inserting, and tightening collets using the provided wrenches.

Install Grinding Wheel

Steps for loosening the collet nut, inserting a grinding wheel shank, and tightening.

Cleaning and Maintenance

Pre-Use Inspection

Safety Caution: Disconnect Air Supply