• Dial number; either internal extension or
external access code + 10 digit number.
• When called party answers, talk toward the
microphone on your telephone.
To Mute a HANDSFREE Call
• You will continue to hear your party but they
can’t hear you.
• Press HANDSFREE/MUTE key.
To Return to a 2-way conversation
• Press HANDSFREE/MUTE key again.
LISTEN ON HOLD
If the person you are talking to puts you on hold,
you can replace your handset and hear through the
speaker when the other party re-establishes the call.
• Press HOLD key (line indicator flashes).
• Replace handset.
• Press the flashing line key. When other party
returns their voice is heard through the speaker.
• Lift handset to resume conversation.
MESSAGE WAITING
When a caller leaves a message in your mailbox
your MESSAGE indicator will be lit.
• Select your line (lift handset).
• Press MESSAGE key to automatically be
connected to the MessageManager
TM
system or
dial the MessageManager number (access code +
10-digit number).
SPEED CALL
SPEED CALL-8 or -10
Lets you personally pre-program and store 8 or 10
frequently called telephone numbers on your
phone. Each phone number is assigned a 1-digit
code (0-7 or 0-9). By dialing the 1-digit code, the
phone number is dialed for you. Speed Call-8 or -10
cannot be shared.
SPEED CALL-30 or -50 or -70
Allows for the pre-programing, storing and sharing
of 30 or 50 or 70 frequently called telephone
numbers. Each phone number is assigned a 2-digit
code (00-29 or 00-49 or 00-69). By dialing the code,
the number is dialed for you. Speed Call-30 or -50
or 70 lists can be shared. If shared, only 1 phone is
designated as a controller and only the controller
can pre-program the phone numbers. Other
phones are programmed with access to use the
Speed Call-30 or -50 or -70 list.
• To Program
• Do not lift handset (no dial tone).
• Press SPEED CALL key (indicator flashes).
• Dial the 1- or 2-digit code + outside access code
+ 10-digit phone number.
• Press SPEED CALL key (indicator goes out).
• Repeat procedure for each number to be added
or changed.
• To Use
• Select a free line.
• Press SPEED CALL key.
• Dial 1- or 2-digit code.
Your Business Set may be equipped with some
features not covered in this guide.
Your communications manager will provide
you with instructions for their use.
MTS STAT 9205
2012-02 (08)
MessageManager is a trade-mark of Stentor Resource Centre Inc. and the MTS design
mark is a registered trade-mark of Manitoba Telecom Services Inc., both used under license.
To Previous Page
Loading...