Need help?Do you have a question about the CentriPro AQUAVAR CPC and is the answer not in the manual?
Steps for physically mounting the drive and connecting power, motor, and control wiring.
Verifying connections, reinstalling the cover, and applying power safely.
Guides the user through the initial configuration and setup of the drive.
Cautions regarding high voltage, heat, and general installation hazards.
Covers requirements for disconnecting devices, fuses, and circuit protection.
Steps for installing the drive, managing cables, and preparing for wiring.
Illustrates terminal layouts for power, control, and single-phase wiring.
Detailed steps for wiring within a conduit using IP 21 / UL Type 1 enclosures.
Instructions for connecting input power, motor, and control signals.
Comprehensive terminal mapping for analog I/O, digital inputs, and relay outputs.
A checklist of essential checks to perform before powering up the drive.
Procedures for reattaching the cover, powering the drive, and initiating start-up.
Details wizard mode, start-up tasks, and changed parameters configuration.
Step-by-step guide for configuring parameters for pressure transducer systems.
Overview, system curve compensation, and pump sequencing for constant pressure.
Details on controlling slave pumps using relay outputs and programming steps.
How the drive displays errors using LEDs, control panel, and fault/alarm words.
Table and guidance for identifying and resolving common drive faults.
Procedures for resetting faults and accessing fault history logs.
General| Enclosure Type | NEMA 4X |
|---|---|
| Communication Protocols | Modbus RTU |
| Phase | Single |
| Type | Pump Controller |
| Accuracy | +/- 1% |
To Next Page