Centroid Acorn Plasma Users Manual Beta CNC12 v4.65 rev6
For Method a. A Float Switch is used as the sole method of touch off:
Wire Conductive Torch Tip according to schematic #S15107
In the Torch Touch Off configuration menu, set “Is a Float Switch being used in conjunction with Torch Tip Touch off?”
to No. the rest of the setting and questions in this menu. then do not apply so no need to set them one way or the
other, they are ignored.
Page 15 D:\Keith Documents\centroid_acorn_plasma_users_manual_draft27.odt rev27 3-15-22
To Next Page
Loading...