Technical instructions CONTROLLER - CPREG-Touch
29
3.0. SCHEDULE
This option is used to set a working time of the burner, DHW tank heating, DHW recirculation pump and to change
daytime and night time temperature of the first and the second heating circuit.
NOTE:
This manual shows the screen with the largest possible number of the basic boiler controller devices where
schedule is available. An actual number of the devices with ordinal device numbers depends on chosen a
selected configuration.
3.1. SCHEDULE - BOILER
This option is used to select a one of the three SCHEDULE tables you have set or to select Schedule: OFF
Possible adjustment: ’’SCHEDULE ’’ :
- Factory: OFF
- Table 1, Table 2, Table 3
NOTE:
You can adjust three differnet tables according to your needs, but one table can be active at the moment only.
3.1.2. TABLE 1/2/3
This option is used to set "SCHEDULE TABLES". Each table can be
set individualy. You can set ON/OFF 3 times during 1 day and every
day can be individualy set.
Schedule
To Next Page