EasyManua.ls Logo

Centrometal CPREG-Touch - Page 49

Centrometal CPREG-Touch
114 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical instructions CONTROLLER - CPREG-Touch
49
Example 4:
Configuration H10 - boiler connected with 4-WAY MIXING VALVE WITH ACTUATOR (backflow protection),
DHW tank and there is a possibility of controlling one or two direct central heating circuits (if one or more CM2K
modules with two heating circuits / DHW are not installed).
Example 5:
Configuration H20 - boiler connected with 4-WAY MIXING VALVE WITH ACTUATOR (backflow protection),
DHW tank with DHW recirculation and there is a possibility of controlling one or two direct central heating circuits
(if one or more CM2K modules are not installed for two heating circuits / DHW).
Example 6:
Configuration H70 - boiler connected with 4-WAY MIXING VALVE WITH ACTUATOR (backflow protection),
DHW tank installed in the boiler and there is a possibility of controlling one or two direct central heating circuits (if
one or more CM2K modules with two heating circuits are not installed / DHW).
Example 7:
Configuration H80 - boiler connected with 4-WAY MIXING VALVE WITH ACTUATOR (backflow protection),
DHW tank installed in the boiler, controlled and recirculated DHW and there is a possibility of controlling one or
two direct central heating circuits (if no one or more CM2K modules with two heating circuits are installed /
DHW).
Example 8:
Configuration H01 - boiler connected with 4-WAY MIXING VALVE WITH ACTUATOR (backflow protection) and
steers one central heating circuit with a motor mixing valve (there is no control of one or two direct central
heating circuits).
Example 9:
Configuration J71 - boiler connected with HYDRAULIC CROSSOVER via 4-way mixing valve with actuator
(backflow protection), DHW tank built into the boiler and steer one central heating circuit with a mixing valve with
actuator.
Remark:
Only configuration of H00, H10, H20, H70, H80 can be defined for directing one or two direct heating
circuits with or without a pump, room corrector or room thermostat only in the absence of one or more
CM2K modules for two circuits heating / DHW.
Heating configuration (markings on the display)