14
10. Maintenance
10.1 Visual inspections
Regularly examine the headset muffs and in particular the ear cushions frequently for signs of fractures,
cracks and wear. If the headset muffs are damaged, replace the headset and send it in to CeoTronics
for repair. Replace damaged or worn ear cushions in accordance with section 10.4, and, even if not
damaged, every 6 months of use at the latest.
10.2 Cleaning
CAUTION
When cleaning ensure that no moisture penetrates inside the unit. Do not use any solvents
(e.g. benzine, alcohol, etc.) for cleaning purposes!
Remove any loose dust with a soft brush. Clean, if necessary, the outside with a suitable clean cloth
that has been slightly moistened with clear water, and rub the parts dry afterwards. If heavily soiled,
some dishwashing liquid can be used in addition. Clean the contacts of connectors with a commonly
available contact cleaning agent.
10.3 Replacing the windshield on the microphone
Pull the windshield (Fig. 8/a) off the microphone and replace it.
10.4 Replacing the ear cushions
Pull the ear cushion (Fig. 8/b) off the headset muff and replace it. Ensure that the new ear cushion fully
engages.
10.5 Replacing the head strap
Remove the two fasteners (Fig. 2/b) and then pull the head strap (Fig. 2/a) out the slits in the headset
muffs. Install the new head strap according to Fig. 2.
11. Accessories and consumable parts
Designation and description Art. No.
Carrying case for transceiver headset, colour grey 40 35 030
Single-unit charger for 3.6 V/2300 mAh NiMH rechargeable batteries, 40 06 543
Ear cushion, 2 pcs. 50 00 501
Windshield for microphone, 10 pcs. 50 02 201
Comfort set consisting of 50 pcs. (25 pair-pack) washable sweat absorbing cotton
pads
40 10 025
Head strap inclusive of two fasteners 50 00 707
To Next Page
Loading...