Cerner Metrologic MS1690 2D User Manual

Metrologic MS1690 2D Scanner
Installation Guide
Revision 1.0

Cerner Metrologic MS1690 2D Specifications

General

Power Supply	5 VDC ± 0.25 V
Humidity	5% to 95% non-condensing
Type	Handheld
Connectivity	USB, RS-232, Keyboard Wedge
Decode Capability	1D and 2D barcodes
Scan Pattern	Omni-directional
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 60°C
Drop Specification	Withstands 1.5 m (5´) drops to concrete
Interface	USB, RS-232, Keyboard Wedge
Light Source	Aiming: 650 nm visible laser diode; Illumination: 630 nm LEDs

Summary

Revision History

Overview of Metrologic MS1690 Scanner Models

LED and Beep Meanings

USB Scanner Setup

PS/2 (Keyboard Wedge) Scanner Setup

RS-232 (Serial) Scanner Setup

Symbology Selection

Setting up Scanner for Cerner Applications

Setting up Scanner for Cerner Millennium Applications

Configure scanner suffix for Cerner Millennium applications, typically to use a Horizontal TAB.

Setting up Scanner for Cerner Classic Applications

Configure scanner suffix for Cerner Classic applications, typically to use a Carriage Return.

Miscellaneous Optional Setup Procedures

Hands Free (Presentation) Mode

Enables presentation mode by placing the scanner in its stand, automatically scanning detected barcodes.

Setting Beep Tone

Adjust the beeper frequency and volume by scanning specific configuration barcodes.

Show Firmware Revision

Reset to Factory Defaults

Sample Bar Codes

Linear Sample Bar Codes

Provides examples of various linear barcode symbologies for testing scanner functionality.

2D Sample Bar Codes

Provides examples of 2D barcode symbologies like PDF417, Aztec Code, and Data Matrix.